Test each side. You should have 12v when ignition is on and 0v when the ignition is off. Power Red Wire The red wire must be connected to a constant power source. Incorrect wiring of the red wire can cause the unit to show incorrect power up events. Good sources are Battery, Alarm System, and Clock. Loosen the bolt, slip the ground wire underneath, and then tighten the bolt. A loose or weak ground connection can result in inconsistent readings from your CalAmp.
Ignition White Wire A switched power source is only on when the ignition is keyed — connect your white harness cable to a switched power source, so that the CalAmp performs the Ignition Off when you turn off the car, and Ignition On when the vehicle is powered on. Good sources are Ignition Switch in fuse box, fuel pump.
From Wiki - RemoteFieldView. CalAmp is a telematics pioneer leading transformation in the connected vehicle and Industrial Internet of Machines marketplace. This harness requires hard wiring of the power, ground and ignition wire. All rights reserved diagramweb. Connect the constant 12 VDC power source to the red wire on the tracking device. Finally, connect the ground wire on the harness to the vehicle ground chassis.
A typical location is under the dash close to the front wind-shield. Attach the LMU to the solid body of the vehicle, not to plastic panels. The LMU can be placed out of sight by removing. Description: Archive Btc, Inc. Here is a picture gallery about calamp gps wiring diagram complete with the description of the image, please find the image you need.
All rights reserved schematron. Connect the constant 12 VDC power source to the red wire on the tracking device.
0コメント